Menu
Tecsun PL-310et antenna Tecsun PL-310et antenna Tecsun PL-310et antenna

Tecsun PL-310et antenna

$7.99 inc. tax
Bulk Buying Options
single: $7.99
2 up to 4: $5.60 per product
5 up to 100: $4.80 per product
Share

Telescopic antenna for the Tecsun PL-310ET radio.

The PL-310ET replacement antenna can easily be replaced without disassembling the receiver. The antenna comes with the original swivel mount. The swivel mount contains pressure washers to ensure good conductivity from the antenna to the brass mounting lug, so replacing the entire assembly is recommended and also the most straightforward. Simply remove the single black screw in the top right hand corner of the rear panel of the radio, the one located right below the antenna, and gently remove the antenna to be replaced. Then insert the new antenna and rotate it until the mounting hole is visible through the rear of the case and insert the mounting screw.



Length while closed: approx. 11.2 cm


Length while open: approx. 54.0 cm


Diameter of pivot screw: approx. 2.4 mm



PLEASE NOTE:   

Is your radio's manufacturing date from before May 2017? 

  • The screw hole at the bottom of this antenna is too large for a 1-on-1 replacement.   

  • As long as the original swivel mount of your old antenna is in good condition, you can still replace the upper section of the antenna. Remove the swivel mount of your old antenna by unscrewing it, and then place it on the new antenna (see photos attached to this listing).

  • Please take extra care when removing the screw from the swivel mount of your old antenna. There are two washers on the inside that tend to get out of position, which can be a little bit tricky.
Product Code: 03-174Te00
Brand: Tecsun
Product Condition: New
weight: 2.0g
Updating Order Details
Please do not refresh or navigate away from the page!
Description
Details
Reviews
No Reviews Posted Yet - be the first!
Product Added to your Cart
x

-------- OR --------